ACUMIX Model AQG mounting options descriptions and drawing links.
Open Tank Designs:
Mounted Mixers - Clamp & Cup-Plate Designs:
Open tank swivel mount. Assumes no
tank lid or top to constrain required final agitator shaft adjustment location.
Tank anti-swirl baffles are not required assuming optimal orientation is
achieved. See drawing links.
Mixers - Base plate & Angle Riser Designs:
ACUMIX Model AQOG: "Lower Headroom" fixed mounted open tank.
Mixer shaft coupling is located below the mixers mounting surface. Used
most often to mount to beams, tank top or lagged into concrete
support. See drawing links.
ACUMIX Model AQPG:
"Pedestal" fixed mounted open tank. Mixer shaft coupling is
located above the mixer mounting surface. Used most often to mount to beams, tank top or lagged
into concrete support.
of the following closed tank options are designed to mount to a mating standard
150# ANSI flange assembly, although other flange options are available.
Each design can be mounted using either a "vertical on tank
centerline" or an "angular offset" mounting
Lip Seal Design:
MODEL AQHG: "Lower Headroom"
closed tank hermetically sealed for at or near atmospheric conditions.
Mixer shaft coupling is located below the mixer mounting base. See drawing
Stuffing Box Seal Design:
Model AQSG: Closed tank stuffing box designs with a
working range of 0-30 PSIG. Pedestal mount locates the mixer
shaft coupling above the mixers mounting base. See
Mechanical Seal Designs:
Model AQMG: Closed tank mechanical seal designs.
Single dry running seal with a working range of full vacuum to 150 PSIG.
Numerous designs are available. Pedestal mount with the agitator
shaft coupling located above the mixers mounting base. See